What would cause a GE washer to not fill with water?
Emily Baldwin
Updated on April 05, 2026
What would cause a GE washer to not fill with water?
If the water inlet valve is defective, the wash may fill slowly or not fill at all. If the water pressure is adequate, try cleaning the screens inside the water inlet valve hose connection ports. If the washer still fills slowly, replace the water inlet valve.
How do I get my GE washer to fill with water?
There are two ways Deep Fill can be used:
- Add a little more water: Press the Deep Fill button once before starting the cycle to add 3 gallons of water to the wash load.
- Full Tub Fill: Press and hold the Deep Fill button for 3 seconds to fill the washer to the maximum water level.
How do I reset my GE Hydrowave washer?
Motor Reset Procedure:
- Unplug the washer for 1 minute from the electrical outlet.
- Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.
- The motor has now been reset and is ready for you to start a cycle.
Why is my new washing machine filling up with water?
Water comes into your washing machine for the wash and rinse cycles through the water inlet valve. So an excess of water at the wash or rinse cycle could be a result of a malfunctioning water inlet valve. If the tub keeps filling, you have a mechanical problem with the water inlet valve and it needs to be replaced.
Is there a reset button on GE washers?
To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. For models that have a timer control knob, turn the knob around and back to any position other than final spin for the interrupted cycle. Then, restore power.
How do I put my GE washer in diagnostic mode?
To enter the LED and buttons test mode on a GE front load washer, rotate the control knob until t04 is displayed in the control panel then press start/pause to enter the test mode. This test mode will test to see if each button works and each LED will light. Each light should blink once in a loop.
